| From | Message |
scottie
Dodge Dakota
JOIN HERE
2/27/2010
02:21:17
|
 Subject: wiring question
IP: Logged
Message:
i recently put a 1997 v6 motor and auto trans in a 1998 dakota and the wiring harness wasnt exactly the same as far as the plugs on the trans i got everything to plug up on the trans but one plug and it wouldnt work because on the 97 the speed sensor was on the trans and not on the diff like on the 98 but i was wondering what the plug on the trans of the 98 would be that is closes to the drive shaft on the left side if its not the speed sensor like on the 97. i mean the truck drives fine and no check engine light i was just trying to figure out wat it is and if i need to just leave that speed sensor unplugged off the trans or make the 98 harness work with it and the difference in the 97 and 98 dak trans
thanks
|
mat
Dodge Dakota
JOIN HERE
3/02/2010
15:33:11
|  RE: wiring question
IP: Logged
Message:
ummm i think i may know what your looking at if your truck is a two wheel drive my 97 is and it has a plug in for 4 wheel drive operation. that plug in is on the trasmission but the speed sensor is on my drivers side right near the drive shaft it has a three wire connector on it
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
