From | Message |
harry frum ct Dodge Dakota JOIN HERE
4/28/2009 22:32:59
|
Subject: gota chirp IP: Logged
Message: gota chirp from the right rear drum...replaced the shoes and the drums.....got any ideas..
|
well Dodge Dakota JOIN HERE
4/29/2009 07:52:00
| RE: gota chirp IP: Logged
Message: Possible:
brake/wheel cylinders worn and sticking
(holding pressure)
& did you clean & ad a little high temp. lube
on the contact points
where the shoes sit/slide on the backing plates?
|
Bob Lincoln Dodge Dakota JOIN HERE
4/29/2009 08:29:43
| RE: gota chirp IP: Logged
Message: Is it with brakes applied, or all the time?
|
harry from ct Dodge Dakota JOIN HERE
5/01/2009 22:05:53
| RE: gota chirp IP: Logged
Message: all the time....even replaced the wheel cylinders when i did the brakejob....had the chirp before and still again....backing plate is not bent or tilted...had a mech look at it and he said...quote...dang if i know....used sprays..grease...brake noise stop...clean it all off with brake clean and ran it dry ..still a chirp......and dont tell me to look for a birds nest on the spare tire...i took that out too.....
|
J and J Auto GenII
5/03/2009 00:58:33
| RE: gota chirp IP: Logged
Message: bad wheel bearing ???
check rear end fluid
you would need to remove cover pull pin push axle
in remove c clip and pull axle take it in and get
a new bearing presed on than reinstal be sure to
also replace the seal
push axle in put c clip on and pull axle out to
seat clip reinstal pin and bolt, cover and refill
Larry J&J Auto
|
harry from ct Dodge Dakota JOIN HERE
5/03/2009 23:11:21
| RE: gota chirp IP: Logged
Message: found it thanks larry....i had a so called mechanic change my rearend fluid a year ago,,he used 80/90 fluid not made for a dodge rearend,,,found out dodge has its own fluid....and it ruined the right wheel bearing....wow gg larry thanks again
|
J and J Auto GenII
5/12/2009 04:10:48
| RE: gota chirp IP: Logged
Message: I run the Amsoil 80 90 in my rears 4x4 127,000
and no bad bearings yet
If its a antispin or sure grip go to chrysler
and get a tube of there additive for that I use it
even when the bottle says you don't have to you
cant always beleave them
Another aditive we use in the rears is the moly
mrmoly.com they are in new york in canada this is
called moly slip US mr moly
Larry J&J Auto
|
harry frum ct Dodge Dakota JOIN HERE
5/12/2009 20:35:16
| RE: gota chirp IP: Logged
Message: i do all my work now and fixed the limited slip to at the same time.....was sick to see how a good 80/90 could not go into a dodge...87000 miles..now im looking for a spooler or a locker for the rear..im get sick of 1 tire wholeshots at the drags///tks again larry
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|