Forums
  Forum Tools
|
|
23:43:38 - 12/19/2024
V6 Dakotas
From | Message |
thanks larry Dodge Dakota JOIN HERE
4/08/2009 21:06:24
|
Subject: you are the best!!!! IP: Logged
Message: Message:
the 1.7 RR's will add aprox .030 lift and 4
degrees duration average gain 15 to 18 rear wheel
hp
The V8 body offers the same gains so doing both
on the low end 30 hp high end 35hp rear wheel
$75 for body and cable is a good price all your
V6 sensors should be used because you know there
good the cable bracket will also bolt right up
when ever you change the TB start and stop motor
3 times it will than learn the new idle than it
will run somewhat doggie at first improve in 50
miles short term learn than around 200 miles
fully learn if you have more modes upto 500 miles
all blocks can be bored .030 most will not take
.060 the walls are just to thin
gasket match the intake ports they are a big
restriction in flow some are so bad the injector
spray actualy hits this and forces the fuel back
into the intake just taking this restriction out
is good for 5 to 10 HP
do the crank sensor mod, relocate the IAT 6" from
throttle body into air tube or air cleaner on
the older daks
TPS volts to .75 just catch the bushings with
a slightly larger drill they will spin heat up
and just push out than use 2 little washers
and do not over tighten
center wire + pos and a good ground use a sewing
needle to back probe the wire key on engine off
to check than strt and stop 3 times to learn new
idle settings
these are free mods that will increase throttle
response
if you get any ping doing the crank sensor mod
than drop 1 heat range on the plugs slot holes and
move down towards oil filter 3 to 4 degree's
advance helps across entire rpm range very
noticeable off idle low end from this mod and
helps gas mileage also
All these mods work as long as all your sensors
are working properly especialy the o2 seeing
more flow it will increase the fuel if not and it
runs worse replace o2 with a good NGK NTK no
bosch or other sensors here they just do not
work well in the dodge motors same as factory
Larry
J&J Auto
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|
|