From | Message |
DakSXT03 Dodge Dakota JOIN HERE
4/03/2009 16:03:06
|
Subject: RE: 3.9L throttle body to 5.9L throttle body IP: Logged
Message: Are there any torque requierments for the TB? I am going to install the 360 TB i picked up this weekend and was curious if i had to torque the bolts back in place
|
Jimmy9190 Dodge Dakota JOIN HERE
4/03/2009 18:21:29
| RE: 3.9L throttle body to 5.9L throttle body IP: Logged
Message: My Haynes book says it's 200 inch-pounds. I don't torque mine, just snug it down then tighten them up. Never had any problems.
Jimmy
|
Da Bumper Dodge Dakota JOIN HERE
4/07/2009 14:49:46
| RE: 3.9L throttle body to 5.9L throttle body IP: Logged
Message: Bump
|
well Dodge Dakota JOIN HERE
4/08/2009 05:47:08
| RE: 3.9L throttle body to 5.9L throttle body IP: Logged
Message: Think with your DipStick Jimmy!
but seriously
the best thing you could do is
cross pattern to avoid warping it
|
Da Bumper Dodge Dakota JOIN HERE
4/08/2009 22:13:04
| RE: 3.9L throttle body to 5.9L throttle body IP: Logged
Message: Bump
|
Dallas Dodge Dakota JOIN HERE
3/16/2011 19:22:31
| RE: 3.9L throttle body to 5.9L throttle body IP: Logged
Message: i have a 92 dodge dakota 3.9L i just installed the electronic turbo kit also a throttle body from 1996 dodge ram they are 50 mm a small ip grade from the stock v6 one also msd 8207 coil and ngk plugs with .045 gap i run k&n oil filter and air filter mine is a 5 speed i also installed a voltage performance chip module found a rear end that was a posi from a 5 speed 4x4 has 4:10 gears stock due to all the mods and braking driver side motor mounts i had to chan the motor block to frame i run a small fab and custom truck shop in layton UT if you have any questions call 801 837 2310 or email cdallas28@yahoo.com i will be glad to help any why i can!!!! all my mods give me 246hp on dyno 317 lb-ft torke hit me up if you need any info
|
| <<Original Post <<Previous Page P 2 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|