| From | Message |
aceofspades
Dodge Dakota
JOIN HERE
5/20/2008
11:55:36
|
 Subject: 01 v6 starter removal
IP: Logged
Message:
automatic tranny, i undid the bolt and the nut and the starter moves foward about a half an inch then stops like its snagged on something, i put my other hand up there thinking it was the tranny cooling lines but theres clearance and i cant feel anything that it could be hitting
its loose so i know i didnt forget a bolt or anything, but it still wont move foward anymore, i cant get it down to test/replace it
please help me figure out whats holding it in so i can get this problem fixed!
thanks
|
daddio
Dodge Dakota
JOIN HERE
5/20/2008
12:11:36
| RE: 01 v6 starter removal
IP: Logged
Message:
have you disconnected the wires from the starter?
the FSM says something about making sure the Trans cooler tube bracket is moved far enough forward to remove the starter from the stud it's mounted on.
|
aceofspades
Dodge Dakota
JOIN HERE
5/20/2008
12:17:11
| RE: 01 v6 starter removal
IP: Logged
Message:
the harness and power cable are still connected since they are on top and i cant see how to get them off in that small space, i thought u took the starter out n hold it and undo the wires, thats what my manual says
and i didnt see or feel a bracket for the tans lines, but ill check again, i pulled it as far foward as i could n stuck my hand up there to feel if it was hitting anything and i didnt feel anything touching the starter
|
aceofspades
Dodge Dakota
JOIN HERE
5/20/2008
16:22:59
| RE: 01 v6 starter removal
IP: Logged
Message:
starters off now, i didnt see any bracket, i didnt know you meant it was where the top bolt goes in, i didnt see it til i had a buddy jiggle the starter while i looked throught the wheel well, thanks for the help as usual
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
