| From | Message |
Michael_John
Dodge Dakota
JOIN HERE
4/24/2002
15:49:39
|
 Subject: super lame question here
IP: Logged
Message:
Okay, It's been a long time since I have replaced spark plugs. I want to put new Autolite 3923s in.
Here's the question. How deep do I run the plug? Until it bottoms out and is tight? I assume yes but want to confirm.
And yes, I'm serious.
thanks in advance.
|
rtdkota
Dodge Dakota
JOIN HERE
4/24/2002
15:55:20
|  RE: super lame question here
IP: Logged
Message:
Not a lame question-- tighten it by hand until it bottoms out (so you don't strip the head), then tighten down w/torque wrench or a socket-- don't over to it.
Make sure when you remove the stock plugs to get the washer as well-- and install the new plugs with the new washer.
Sam
www.socaldakota.com
|
michael_john
Dodge Dakota
JOIN HERE
4/24/2002
16:12:09
| RE: super lame question here
IP: Logged
Message:
thanks a ton... I read all these posts about guys making huge mods to their trucks and I just want to do a basic one and not screw it up! ; )
thanks much rtdkota!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
