| From | Message |
sport02
Dodge Dakota
JOIN HERE
12/08/2007
00:35:10
|
 Subject: control arms
IP: Logged
Message:
are the bushings in the control arms pressed in? in other words, is this a job that can be done without some type of press? i might need new bushings and want to know ahead of time if i can do this without a press? thanks
|
dakota49
Dodge Dakota
JOIN HERE
12/08/2007
19:44:15
| RE: control arms
IP: Logged
Message:
sport02, I've never done that on a Dakota before, but my repair manual says to remove the control arm and take to a shop to have the bushings replaced, so I assume they will need to be pressed out/in. I have done them on an old Buick before and only needed to use a gear puller to remove/install, wasn't much of a problem at all, still, I don't know about the Dak.
Good Luck
Dakota49
1988 3.9 4X4 5speed
|
J and J Auto
GenII
12/13/2007
06:41:24
| RE: control arms
IP: Logged
Message:
energy suspensions
for a few dollars more get polyurathan bushings
It will make your truck handle better no flex
like the rubber
Listed for some trucks like my 95 I had to
remove and mesure them
a arms shock and rear leaf wow what a dif in
handling
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
