| From | Message |
Ron Beers
Dodge Dakota
JOIN HERE
11/18/2007
11:32:11
|
 Subject: Blinking ABS Light
IP: Logged
Message:
Today I replaced the ECM on my Dakota with a used part. After installation my ABS light immediately began blinking, but no codes were returned from the OBD module. Thought maybe the used part was bad so I reinstalled original ECM. Same problem with the light. How can I reset the ABS system???? I've read on some forums of other vehicles that such a procedure exists. Other than that, truck is running better than ever.
|
?
Dodge Dakota
JOIN HERE
11/19/2007
14:07:41
| RE: Blinking ABS Light
IP: Logged
Message:
Have you tried the usual 'reset' ?
Disconnect battery negative cable , turn key on then to start position , then back off again.
Then reconnect battery ,and start her up ..
|
s10355
Dodge Dakota
JOIN HERE
11/20/2007
18:47:50
| RE: Blinking ABS Light
IP: Logged
Message:
i had same problem.used pcm needs your vin and dealer to clear abs.
|
roman_ltd
Dodge Dakota
JOIN HERE
12/13/2007
22:24:14
| RE: Blinking ABS Light
IP: Logged
Message:
same problem here ..
none of usual "resets" will help
sorry to say!! dealer is the only way.
but if you want some performance -talk to David at bg chrysler specialists www.bgchrysler.com
they do some real good upgrade.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
