| From | Message |
big blue
Dodge Dakota
JOIN HERE
10/06/2007
23:52:10
|
 Subject: v6 throttle body wiring
IP: Logged
Message:
Okay here is a quick rundown...I had a 1990 dodge dakota that I did a straight axle swap and ran it as my 4x4 till I rolled it several times and it no longer was a good offroad truck....I then bought a jeep and swapped the engine into the jeep. I have been trying to figure out the wiring..I got it to run on starting fluid and pouring gas in the carb....but I dont think this would be acceptable when I want to actually get it out of my garage...the problem is I cant fingure out how to get the tbi to work...any ideas? or is there a wiring diagram? i have a couple diagrams that i have used to get the rest working but I have no luck with the throttle body..please help. thanks
|
N56629
Dodge Dakota
JOIN HERE
10/07/2007
15:59:43
| RE: v6 throttle body wiring
IP: Logged
Message:
Seems like it would be less work converting it to a carbed engine.
|
big blue
Dodge Dakota
JOIN HERE
10/07/2007
16:35:33
| RE: v6 throttle body wiring
IP: Logged
Message:
it would, but a carbed engine wont like to run at the angles I put my jeep in. I just dont seem to have any poer to any of the wires on the throttlebody. If I can get my hands on a good aftermarket two barrel Ill just carb it and get back to wheeling. Does anyone have any wire diagrams? I dont want to buy the manual since I will never need it again. thanks
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
