| From | Message |
chris
Dodge Dakota
JOIN HERE
3/03/2007
19:56:21
|
 Subject: a500 transmission
IP: Logged
Message:
have a 97 dodge dakota with a a500 trans
i keep getting a p0748 code ive replaced all Solenoids and Govenor pressure Sensor
still geting the same code but to shift i have to shift by hand 1- 2- and D to drive
it is driving crazy need help please thanks
|
TDKnight08
Dodge Dakota
JOIN HERE
3/03/2007
23:09:54
|  RE: a500 transmission
IP: Logged
Message:
did you reset the computer after the new sensors were put in?
|
TDknight08
Dodge Dakota
JOIN HERE
3/05/2007
20:56:37
| RE: a500 transmission
IP: Logged
Message:
did that fix your problem?
|
J and J Auto
GenII
3/05/2007
23:25:20
| RE: a500 transmission
IP: Logged
Message:
you need to check the electrical connection
drivers side by shift lever clean and spray
out with contact clean, break clean carb clean
or just starting fluid this will remove any
mosture in the plug
both sides plug and on trans
also a bad ground will also cause this check
grounds
one other thing you may not want to here is I
have gotten new sensors and sols that were bad
new but bad chrysler is awre of this and will
give you another new set free
just some things I have run into
also in the cooling line there is what looks like
a valve what it is, is a check valve to help
with converter drain back these sometimes stick
and will cause problems like you described
remove or replace do not try to clean or fix this
it will just happen again
not all trucks have this but check it out
these are all common probs with the RE trans
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
