| From | Message |
markmith
Dodge Dakota
JOIN HERE
10/20/2006
19:35:51
|
 Subject: Crank Position Sensor
IP: Logged
Message:
Where would the CPS be located on my 92 Dodge dak. 3.9 w/ manual trans?
|
markmith
Dodge Dakota
JOIN HERE
10/21/2006
08:22:58
|  RE: Crank Position Sensor
IP: Logged
Message:
Please Help...
|
daddio
Dodge Dakota
JOIN HERE
10/21/2006
09:49:01
|  RE: Crank Position Sensor
IP: Logged
Message:
should be on passenger side back of block right below the head. it goes into the bellhousing .
|
J and J Auto
GenII
10/26/2006
00:40:05
| RE: Crank Position Sensor
IP: Logged
Message:
the 92 to 95 original sensor had a plastic top
with bushings
the replacement and the newer modles this was
changed to a steel top
remove, slot and move down towards oil filter
be sure you remove the rubber gromit from hole
so it will move over
a 3 to 4 degree advance posible here better
gas mileage and a power increase accros the
entire rpm range
Larry
J&J Auto
|
daddio
Dodge Dakota
JOIN HERE
10/26/2006
08:49:01
| RE: Crank Position Sensor
IP: Logged
Message:
Larry, my '00 has an all plastic CPS. maybe it's a 5spd thing.
|
zzark
*GenII*
10/26/2006
17:11:21
| RE: Crank Position Sensor
IP: Logged
Message:
When I went from plastic to metal, I had to use a spacer (nut) because the original bolts were too long for the metal bracket.
zzark
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
