| From | Message |
rngr_killer
Dodge Dakota
JOIN HERE
8/16/2006
19:56:06
|
 Subject: torque sensor mod
IP: Logged
Message:
can anyone tell me were and how to mod the torque sensor in my 2000 V6 dakota. i got some mods on it...comp.chip,gibson headers,52mm throttle body,no cat header mufflers.
|
ES
Dodge Dakota
JOIN HERE
8/17/2006
17:08:54
| RE: torque sensor mod
IP: Logged
Message:
There isnt one i made a big post a while back after reading that we might have had one and found nothing.
It was on the early 4.7 v8 autos only and they were just a simple snip of a wire.
Now if ur asking how do u control torque converter lockup? Well there was a post a while back on here and maybe they can chime in to help u out.
|
rngr_killer
Dodge Dakota
JOIN HERE
8/17/2006
19:37:40
| RE: torque sensor mod
IP: Logged
Message:
thanks you dont know any other cool tricks do ya?
|
ES
Dodge Dakota
JOIN HERE
8/17/2006
23:22:40
| RE: torque sensor mod
IP: Logged
Message:
Well there is the crank sensor mod.
All u do on that is slit the mounting holes and pull the rubber piece out and slide it to advance or if u wish retard timing. Thats found at the passenger side between the bellhousing and motor.
Another well liked one is to take the IAT
(Intake Temperature Sensor)and relocate it to a cooler place(such as intake tube) so the vehicle runs a more aggressive timing and fuel curve.
The sensor is found on the passenger side toward the front of the intake manifold, its the little brass thing with wires going into it. It just takes a 1/4" pipe plug to plug the hole it threaded into.
The iat is the only mod i did where i didnt notice a differance around town, but on the interstate its was a difference between holding my speed up a hill or accelerating up a hill.
|
GB2000
GenIII
8/18/2006
14:24:22
| RE: torque sensor mod
IP: Logged
Message:
http://www.blackshireserver.net/OhioDakotas/pdf/Speedtweaks%20Tips%20And%20Tricks.pdf
|
GB2000
GenIII
8/18/2006
14:38:00
| RE: torque sensor mod
IP: Logged
Message:
Crank position sensor mod...for if you got an auto tranny...if you got a manual, it'll give you the basic idea but stuff may look a lil different and be located in different places.
http://www.blackshireserver.net/OhioDakotas/docs/Crankshaft%20Position%20Sensor.doc
|
J and J Auto
GenII
8/21/2006
22:53:39
| RE: torque sensor mod
IP: Logged
Message:
I think he ment the crank sensor
The obd2,s the comp can be reflashed to do
anything you want trans, timming fuel
o/d and lockup the first 3 gears firmness all
with the comp
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
