| From | Message |
zzark
*GenII*
4/13/2006
10:37:40
|
 Subject: pushrod length ??
IP: Logged
Message:
Other posts suggested 6.900 and 6.905,
but the specs show 6.794-6.814
Hughes has the 6.905 and 6.804
So which should I get?
Why did Larry say 6.905?
Thanks
zzark
|
J and J Auto
GenII
4/14/2006
09:23:49
| RE: pushrod length ??
IP: Logged
Message:
Acording to mopar they are 6.925 but the stock
rods mesure 6.905 the performance 6.930 KRC sells
the 6.950 hardened
With the stock length you have a .050 preload in
the lifter rollers require .030 any will work
here and changes the geomotry very little nothing
to worrie about just no shorter than 6.905 no
longer than 6.950 .045 will not change anything
Larry
J&J Auto
|
zzark
*GenII*
4/14/2006
11:12:56
| RE: pushrod length ??
IP: Logged
Message:
Hello Larry,
That's where the difference shows----
The Mopar of 6.905/6.925
and the specs from my CD 6.794-6.814
VALVE LIFTERS TABLE
Application In. (mm)
Bore Diameter ................ .9051-.9059 (22.990-23.010)
Lifter Diameter .......... (1) .9035-.9040 (22.949-22.962)
Oil Clearance .................... .0011-.0024 (.028-.061)
Push Rod Length .............. 6.794-6.814 (172.57-173.08)
(1) - Standard diameter valve lifter is listed. Oversize
valve lifters are available in .001" (.02 mm), .008"
(.20 mm) and .030" (.76 mm).
That is from the CD.
?????????
Thanks
zzark
|
J and J Auto
GenII
4/16/2006
11:56:11
| RE: pushrod length ??
IP: Logged
Message:
Take one out and messure with a 12" dial caliper
they mesure 6.905 and in the chrysler manuals
they list as 6.925
I just bought a new set from chrysler and they
were 6.905
I also just put a set in a 360 orderd the perf
part # and they messured 6.930
Try this go to napaonline.com they list as 6.924
Larry
J&J Auto
|
zzark
*GenII*
4/17/2006
08:33:20
| RE: pushrod length ??
IP: Logged
Message:
Thanks Larry.
I'll order the 6.905
zzark
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
