| From | Message |
Odessa
Dodge Dakota
JOIN HERE
4/01/2006
22:24:56
|
 Subject: Removing gearshift and throttle levers
IP: Logged
Message:
I'm trying to remove these 2 which are connected to the valve body manual lever shaft on the tranny, but have no luck so far. I got the 2 bolts out that were on each of the levers, but what's next? I'm trying to pull it up (by hand, by tool, slammed it with hammer), but nothing. The gearshift has some play (it's on the bottom), but the throttle is dead frozen. Am I doing it right??
Truck is a 97 2wd auto, and 42re tranny.
|
Odessa
Dodge Dakota
JOIN HERE
4/02/2006
03:36:22
| RE: Removing gearshift and throttle levers
IP: Logged
Message:
Nevermind, a little wd-40 and hammer solved the problem!
|
J and J Auto
GenII
 
4/02/2006
12:12:30
| RE: Removing gearshift and throttle levers
IP: Logged
Message:
You don't need to completly remove the bolts it
just makes it harder to reinstall just losen them
Larry
J&J Auto
|
Odessa
Dodge Dakota
JOIN HERE
4/02/2006
21:35:20
| RE: Removing gearshift and throttle levers
IP: Logged
Message:
Too late now. But I don't worry much about the bolts. I worry more about how it will go down on the shaft.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
