Forums
Forum Tools
|
 |
23:32:07 - 12/19/2024
V6 Dakotas
| From | Message |
Alex mls
Dodge Dakota
JOIN HERE
2/05/2006
20:09:41
|
 Subject: intake,fule injectors,heads
IP: Logged
Message:
I have a 97 V6. Mods already done: series 40 flow master, cold air intake W/ K&N filter , T.B. spacer, Jet stage 2 chip, Bosh 4 pin spark plugs. What intake manifold will give me the max. H.P. and when i do the mod., should i replace the fule injectors? will i need to get a bigger fule pump? what are good inexpensive headers ?
Thanx for any input,
|
J and J Auto
GenII
2/08/2006
00:17:31
|  RE: intake,fule injectors,heads
IP: Logged
Message:
There are no aftermarket intake manifolds for the
V6 however hughesengines.com has mod stock units
or do it yourself
gasket match
remove devider
shorten runners
Getred of the spacer and put either a V8 96 or
newer for your 97 throttle body or a fastman 46mm
or F&B 48mm
try the stock champ or autolite 3923 1 range
colder plugs they will run better than the bosch
4's
Injectors fiveomotorsports.com FMS bosch 19 lb
for your 97 they are matched closer and will
give you a smother idle better mid and top end
and an overall smother running motor
The 1.7 roller rockers will also help a lot
15 to 18 rear wheel hp
harland sharp bolt in
crower requier adjusting
After the intake side is done a low restriction
exhaust will help headers and cat back
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
