Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
22:50:33 - 12/19/2024

V6 Dakotas
FromMessage
stumped
Dodge Dakota
JOIN HERE
 Email

12/20/2005
05:31:55

Subject: 89 dodge dakota
IP: Logged

Message:
this thing is driving me crazy could someone try to help me please.. my truck started missing really bad so bad that sometimes it won't even pull out of it's tracks. i changed plugs wires cap cleaned throttlebody then did a self diagnostic check and got reading that it was in the throttle solenoid so i then change that now i get a reading (fault in part throttle unlock solenoid drive circuit) does this mean that it is in the computer. can someone give me a or some suggestion to help me get my truck running again please



Dan M
Dodge Dakota
JOIN HERE
 Email

12/20/2005
08:06:43

RE: 89 dodge dakota
IP: Logged

Message:
what was the code?

several sensors can cause that.

- Dan M



stevo
Dodge Dakota
JOIN HERE
 Email

12/27/2005
08:01:46

RE: 89 dodge dakota
IP: Logged

Message:
Hello here are a couple things to look out for first pull off the air cleaner and when you put the key in the on position check to see if the throttle position syloniod on the left side of the throttle body moves then start the truck it should move to set you're throttle then put a load on the engine and make sure that motor keeps the idle up to about 800rpm. Second pull you're cap and rotor and try to wiggle the relucter pick-up and shaft if it slaps around replace the distributor this will cause the simptoms you're describing. last just go around with a meter and check the rest of you're sensors & egr circuit. Hve fun



Jay
Dodge Dakota
JOIN HERE
 Email

1/12/2007
16:37:12

89 dodge Dakota No Overdrive
IP: Logged

Message:
Its throwing a code 34 "An open
or shorted condition detected in the speed control vacuum or vent solenoid
circuits." I dont have a clue what that means. Its been to every shop in my town and no one can fix it. This tranny acts the same as the other one that was in it. Fluids and filter has been changed and when they put their scan tool on it it shows its going into overdrive. Any one have a clue? Thanks



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.