| From | Message |
paul
Dodge Dakota
JOIN HERE
8/27/2005
22:36:28
|
 Subject: computer reset
IP: Logged
Message:
I just found a throttle body from a 94 5.9 all the sensors are still on should I swap them and I was readind that I need to reset my computer how do I do this any help would be nice.
|
?
Dodge Dakota
JOIN HERE
8/31/2005
11:37:03
|  RE: computer reset
IP: Logged
Message:
Yes you should swap the sensors .
However , a throttle body from a 5.9 may be a
little much for a 3.9 , if you are posting in
proper post ?
Better to have from a 5.2 = 318 cu. in.
No need to " reset " computer = it will learn
by itself - takes 2 to 4 trips over 10 miles each.
If you want to reset computer to basic start
just disconnect battery negative , turn key to ON
and then to start , then back off ; reconnect battery , and Go..
|
no
Dodge Dakota
JOIN HERE
8/31/2005
11:42:36
| RE: computer reset
IP: Logged
Message:
a tb from a 5.2 and a 5.9 are the same. the stock v8 tb is not too big.
|
KJS
GenIII
8/31/2005
22:28:06
| RE: computer reset
IP: Logged
Message:
the only tb that can be used on a 3.9L v6 is the 5.2, the 5.9 will not work as it is a tad to big, the 3.9 is just like the 5.2 minus 2 cylinders.
My truck looks like it was in a knife fight, and lost! http://www.cardomain.com/ride/1275365
|
paul
Dodge Dakota
JOIN HERE
9/01/2005
00:13:53
| RE: computer reset
IP: Logged
Message:
yes I found out it cane from a 94 5.2 so all is good got 60 mi since install so far so good the only thing it smells like gas when it's cold.
|
Wadak
GenIII
9/01/2005
01:24:43
| RE: computer reset
IP: Logged
Message:
When I installed a v8 throttle body on my v6, it came off of a 99 Dodge Durango with a 5.9 and it worked just fine. The throttle bodies for the 5.2 and 5.9 are identical in size. The throttle body plates are 50mm in size. the Throttle body bores are reduced to 47.5mm right above the throttle plates, this is known as the torque step. If you use the v8 throttle body unmodified it will work just fine on the v6. Use the sensors off of your v6 TB. Just the cleanup the area where you mount the IAC-Idle Air Controller, it will get carboned up. You can clean it up carb cleaner, just before with the IAC sensor itself.
92 and 97 Daks both with many mods.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
