| From | Message |
cris
Dodge Dakota
JOIN HERE
3/24/2002
18:49:49
|
 Subject: v6 harnes
IP: Logged
Message:
Any one out there ever convert a v6 engine harnes
to work on a v8? I am swaping a 3.9 for a 5.2.
|
bernd
*GenIII*
3/24/2002
23:37:35
|  RE: v6 harnes
IP: Logged
Message:
You'll need the injector harness at minimum. Don't forget the PCM, transmission, driveline, and differential. (Should be ok with the 8.25" without too many modifications though.)
1997 Dodge Dakota SLT - V6
Supercharged/Intercooled @ 10# w/Nitrous
14.55 @ 96.01mph
|
CW
GenIII
3/25/2002
09:20:04
|  RE: v6 harnes
IP: Logged
Message:
So are you swaping to a 9.25" diff Bernd. With that new engine it is better than a V-8 with a few mods. What about the trans? hehe JUst going by your advice;)
2001 4.7 RC 5sp 3.92 LSD
Click on thumbnail for mods.
|
cris
Dodge Dakota
JOIN HERE
3/25/2002
22:05:09
| RE: v6 harnes
IP: Logged
Message:
Hey again
What I have is a 94 auto 3.9 and a 5.2 out of a
97 ram low km. I have complete engine harnes and computer,I know the computer and harnes are different than my dakota but I think I can wire in the other 2 injectors to the computer with the proper pin locations.
Also about the automatic I know it will bolt up but many people say it won't hold up.
Bernd what did you do to yours to hold up to the mods you did?
Cris.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
