| From | Message |
4wheelhigh
Dodge Dakota
JOIN HERE
6/15/2005
16:11:10
|
 Subject: dakota wont start
IP: Logged
Message:
Hello I have a 1993 dakota 3.9 liter 2x4 automatic, yesterday morning I went out to my truck and it wouldnt start turned over easly but wouldnt start and later that afternoon i went out to make sure it was getting spark and it started and ran fine and this morning i went out there and it wouldnt start agian and I dont know whats wrong with it. It has gas in it and i replaced the fuel filter, plugs,wires,distributer cap and roter about 6 months ago and i didnt have any problems with it until yesterday. Any help would be greatly appriciated.
|
Bob Lincoln
Dodge Dakota
JOIN HERE
6/15/2005
16:19:48
| RE: dakota wont start
IP: Logged
Message:
Check fault codes.
|
daddio
Dodge Dakota
JOIN HERE
6/15/2005
16:34:22
| RE: dakota wont start
IP: Logged
Message:
you may want to check that factory splice leaving the power dist box. do a search on here. it's been discussed several times.
|
4wheelhigh
Dodge Dakota
JOIN HERE
6/15/2005
17:19:05
| RE: dakota wont start
IP: Logged
Message:
thankyou daddio I never would have looked there, but I went out there and found what i think is that connection its 1 red wire with a white tracer going into 3 red with white tracers is this the correct one. And how do I go about fixing this connection.
|
daddio
Dodge Dakota
JOIN HERE
6/15/2005
17:43:45
| RE: dakota wont start
IP: Logged
Message:
unwrap it, it could be all corroded and greenish looking. if it were me, i'd solder everything up and use heat shrink tubing and tape to cover it all up nice and tight.
i hope it's as easy as that for you. good luck
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
