| From | Message |
NUB
Dodge Dakota
JOIN HERE
5/21/2005
13:50:44
|
 Subject: MSD 6A
IP: Logged
Message:
alrighty i must be stupid but i am looking at this and then looking at my engine and i am totally like umm i think i understand but i wanna make sure before i turn the key. The heavy red wire goes to the battery, the heavy black wire goes to the barrty, the orange and black wire goes to the SS Blaster Coil, the red wire goes to the orinal coil postive, the white goes to the oringal coil negitive, and the megnetic pickup is not used. If this is correct i guess i am worried for no reason but i just wanna make sure. This is my first time actually doing something to my engine and i dont really know anything about vechials so i thought id ask.
Thanks in advance.
~the new nub
|
Dingo
Dodge Dakota
JOIN HERE
5/21/2005
14:20:56
|  RE: MSD 6A
IP: Logged
Message:
Don't know weather this will help, but you may find something http://www.msdignition.com/downld1.htm
|
NUB
Dodge Dakota
JOIN HERE
5/21/2005
14:25:47
| RE: MSD 6A
IP: Logged
Message:
thats the manual that i got with the amp.
|
J and J Auto
GenII
 
5/26/2005
08:04:41
| RE: MSD 6A
IP: Logged
Message:
Big red bat plus
big black ground
orange coil plus
black coil neg
red coil signal
wite coil power
you can test these
remove fuel pump relay so you do not flood engine
while cranking
red wire to exsisting coil wire black ground with
volt meter
1 wire will jump volts up and down this is signal
red wire
1 wire will read a constant voltage wite on off
check while cranking motor over
Larry
J&J Auto
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
