| From | Message |
Relf
Dodge Dakota
JOIN HERE
5/20/2005
23:52:24
|
 Subject: V6 Intake Manifold
IP: Logged
Message:
I am looking for a V6 intake manifold that will fit on a '98 Dakota. Does anybody out there have one for sale? The junk yards in my area just don't seem to have them. Thanks, Relf.
|
screwuphead
Dodge Dakota
JOIN HERE
5/20/2005
23:58:48
|  RE: V6 Intake Manifold
IP: Logged
Message:
thats actually a good qustion, ive been shoping around and havnt seen seen one except for the stockers that you can buy at any dodge dealership
|
N56629
Dodge Dakota
JOIN HERE
5/21/2005
00:03:32
| RE: V6 Intake Manifold
IP: Logged
Message:
You haven't seen any because there aren't any.
If you are looking for a stock manifold, try eBay or carpart.com
|
another mark
Dodge Dakota
JOIN HERE
5/21/2005
00:03:38
| RE: V6 Intake Manifold
IP: Logged
Message:
www.car-part.com
|
J and J Auto
GenII
5/21/2005
06:01:42
| RE: V6 Intake Manifold
IP: Logged
Message:
Hughes engines sells 2 reworked stock manifolds
stage 1 & 2
ports are cleaned runners shortened and filled to
reduce volume
I am running a stage 2 on my new stroker motor
nice intakes
They also sell a nice asortment of cams and
pistons pushrods lifters anything you want for
the V6
both have the same 48mm bores I opened mine to
50mm and have a 50mm F&B sitting on it
Larry
J&J Auto
|
Relf
Dodge Dakota
JOIN HERE
6/19/2005
13:09:16
| RE: V6 Intake Manifold
IP: Logged
Message:
If I reworked my own manifold, how do I re-fill material back into the casting so I don't increase volume? What is the material? Where do you put the material? Couldn't I just make a 1/4" plenum plate from aluminum and mill a step around the periphery of the plate, so when I attatch it, the plate sits into the manifold a bit? Relf.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
