| From | Message |
low99dakota
*GenIII*
3/16/2002
00:17:58
|
 Subject: stock pipe size
IP: Logged
Message:
Is the stock exhaust pipe size 2.25 or 2.5"? I am about to pick up a Flowmaster Delta 40 series, and need to know the inlet size to get. Also, I am just putting in the muffler for now, with a turndown tip. Should I get center in, center out, or center in , offset out? Thanks!
Justin
|
LI Blackdak
Dodge Dakota
JOIN HERE
3/16/2002
01:35:09
| RE: stock pipe size
IP: Logged
Message:
gen 3 is 2.5
|
low99dakota
*GenIII*
3/16/2002
10:52:55
| RE: stock pipe size
IP: Logged
Message:
So I need a 2.25 inlet correct, so the 2.5 pipe will fit over it? Sorry if this souds stupid, just making sure. Also, any thoughts on the inlet/outlets? I was thinking center in/out.
|
LI Blackdak
Dodge Dakota
JOIN HERE
3/16/2002
12:07:23
| RE: stock pipe size
IP: Logged
Message:
im not sure actually, isnt 2.25 too small? i dont know. i dont think it will fit in a 2.25
|
DakotaDan
GenIII
3/16/2002
17:52:05
|  RE: stock pipe size
IP: Logged
Message:
Justin
When I ordered my DynoMax muffler it came 2.5" in & 2.5" out and it slid right over the stock (2.5") pipes .
Exhaust tubing is measured by "OD"
mufflers are sold by the "ID" so the tubing will slid inside.
If you ordered a 2.25" in muffler you would have to butt weld it to your stock pipe as it wouldn't slid over 2.5" pipe.
Dan
|
low99dakota
*GenIII*
3/17/2002
21:47:33
| RE: stock pipe size
IP: Logged
Message:
Thanks for the clarification!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
