| From | Message |
craig
Dodge Dakota
JOIN HERE
12/16/2004
21:41:22
|
 Subject: crank position sensor
IP: Logged
Message:
I'VE GOT A V6, THAT JUST QUITS, AND WONT RESTART, REPLACED THE CPS THREE TIMES. TRUCK WILL RUN GOOD FOR A COUPLE DAYS AND THEN JUST QUIT AGAIN, WHAT WOULD CAUSE THIS PROBLEM? ALSO I'V SEEN A FLASH IN THE LIGHTS AND THE TACK GO'S CRAZY, JUMPING UP AND DOWN. ANY IDEAS CRAIG
|
?
Dodge Dakota
JOIN HERE
12/17/2004
08:02:44
|  RE: crank position sensor
IP: Logged
Message:
No need to post in CAPS = that is yelling..
Anyway - sounds like an electrical problem..
Check ASD relay and the wiring around it..
May be a good idea to clean battery posts and
all connectors that you can see in the main
heavy cables..
|
craig
Dodge Dakota
JOIN HERE
12/17/2004
14:12:58
|  RE: crank position sensor
IP: Logged
Message:
Thanks, I didn't mean to use caps. what is a ASD relay? and where may i find it thanks again craig
|
seth
Dodge Dakota
JOIN HERE
12/20/2004
23:47:08
| RE: crank position sensor
IP: Logged
Message:
what year is your truck. If its 97 or newer, it could very possibly be the computer, let me know what year it is
|
J and J Auto
GenII
12/20/2004
23:51:30
| RE: crank position sensor
IP: Logged
Message:
Check all your grounds
kick pannel pass side remove, than bolt and sand
between dash and cab put bolt back in
A bad ground will make all guages act strange
Also check your fuel presure when it don't start
Larry
J&J Auto
|
craig
Dodge Dakota
JOIN HERE
12/21/2004
19:24:26
| RE: crank position sensor
IP: Logged
Message:
the truck is a 95 slt with 3.9 auto tran. iv check all wires, grounds and wire under hood. I'm begining to think that its the computer acting up. As luck would have it i can't find one any were, except from dodge, at the tune of $1000.00 dollars. Any ideas Thanks Craig
|
Jason Oram
Dodge Dakota
JOIN HERE
12/30/2004
10:35:54
| RE: crank position sensor
IP: Logged
Message:
I replaced the CPS on my 95 V6 and the thing ran fine for 6 to 8 months. It has since failed again and I have another CPS on order to try. Is there any way to test the sensor? and is there anything that will cause to sensor to go?
|
Jason Oram
Dodge Dakota
JOIN HERE
12/31/2004
13:03:19
| RE: crank position sensor
IP: Logged
Message:
I found some info. Check this out.http://www.autozone.com/servlet/UiBroker?ForwardPage=/az/cds/en_us/0900823d/80/10/10/e6/0900823d801010e6.jsp
|
Woody
Dodge Dakota
JOIN HERE
12/31/2004
20:47:57
| RE: crank position sensor
IP: Logged
Message:
I would check the connection for the ASD thats in the harness underneath the fusebox under the hood,On my '94 V6 that was the problem...the splice had corroded and broken in two,engine would turn over but thats it,before it spit the bit though all of the gauges were jumping & flickering..theyre steady now. Hope this helps.
Also for whats its worth,the first thing that I replaced was CPS...nothing..took it back & got a refund.Check the wiring under the fusebox thats under the hood...That should fix your problem.
|
big bird
Dodge Dakota
JOIN HERE
1/09/2005
10:13:40
| RE: crank position sensor
IP: Logged
Message:
Yep , Red Wire /white stripe I b-leve heavy gauge ... right @ the splice under fuse block ! Also seen a coil do this but the tach wuz the only gauge affected ! Good Luck !!!
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
