| From | Message |
rdkc01
Dodge Dakota
JOIN HERE
11/17/2004
14:36:02
|
 Subject: 11/P1391 & 43/PO351
IP: Logged
Message:
I just completed several mods and repairs to my 1997 3.9 and now I have two error codes showing up. The first 11/P1391(Loss of Cam Or Crank) I'm not sure about the cause. Bad crank or cam sensor right after these repairs is suspect. The second 43/P0351 (Ignition Coil #1 Ckt) I assume is because of the MSD ignition mod so I belive the 8910 Tach adapter should fix that. ( I was told I didn't need one for this model)
The truck runs fine. I'm sick of looking at the check engine light. PLEASE HELP.
|
J and J Auto
GenII
 
11/17/2004
17:08:33
|  RE: 11/P1391 & 43/PO351
IP: Logged
Message:
Most obd2 systems will trow the coil code without
the tach adapter.
Check the plug on the crank sensor, located pass
side behind the head hard to see on G3's the plug
head you will find running behind the dist towards
the other side. 2 wire plug
Now disconnect batt turn key all the way to start
for 30 secs, shut off reconnect batt and start
this will clear the codes
Be sure MSD is hooked up right using the 2
exsisting coil wires (signal & on off) big red
12 volt batt and big black ground and you should
be ok
Larry
J&J Auto
|
rdkc01
Dodge Dakota
JOIN HERE
11/17/2004
19:19:21
| RE: 11/P1391 & 43/PO351
IP: Logged
Message:
Larry;
Thanks for all the help during the last week.(emails) You have been a great help.
Just unpluged the crank sensor and pluged it back in. Ran the truck for about 15 min. after clearing the codes and the check engine light has not come back yet. The last time it took a while to come back on. I've got my fingers crossed!
|
rdkc01
Dodge Dakota
JOIN HERE
11/18/2004
13:26:24
| RE: 11/P1391 & 43/PO351
IP: Logged
Message:
IT"S BACK!! I double checked the connections from the crank sensor and cam sensor to the harness. My friend had an extra cam sensor so I just swaped this out cleared the codes and 20 min. of running later it's back. Again the truck runns great just keep getting the check engine light.
HELP
|
cedric
Dodge Dakota
JOIN HERE
6/22/2008
14:24:11
|  RE: 11/P1391 & 43/PO351
IP: Logged
Message:
I can,t find my crankshaft sensor location. Please help me
|
J and J Auto
GenII
6/22/2008
23:33:07
| RE: 11/P1391 & 43/PO351
IP: Logged
Message:
All mag motors located behind pass side head
in the bell housing
The G3 trucks a lot of guys will pull there inner
fender well to do the sensor mod
The older G2 it was easy at least you could look
back there and see the sensor LOL
Larry
J&J Auto
|
skitbo
Dodge Dakota
JOIN HERE
2/17/2011
18:49:21
| RE: 11/P1391 & 43/PO351
IP: Logged
Message:
i was wonderging if anyone new what would case the coil to go bad over and over the problom i am having is i could be driving along and all the son the van just dont have power then all the sun it pop s back on and happens again in a few miles but sometimes i can drive with out issues the van i have is a 1997 dodge ram b2500 withy a 3.9 v-6 i had the whole ignition system replaced the timing chain replaced the opild pump replpaced runs like a charm but it does have the lil isse with the just dying and some times the truck engin dies but not much
|
odyssa
Dodge Dakota
JOIN HERE
11/20/2011
22:05:26
| 1997 dodge dakota
IP: Logged
Message:
can any one help me my truck has been wrecked and i have gotten mulitiple people to look at it when i cranck the truck the light go bright then deem i have put to new alternators on it and it cuts off when i push the gas does anybody know wats going on with it?
|
yeah
Dodge Dakota
JOIN HERE
11/21/2011
18:52:02
| RE: 11/P1391 & 43/PO351
IP: Logged
Message:
check for fault codes
|
po351dakota
Dodge Dakota
JOIN HERE
12/15/2011
15:19:59
| RE: 11/P1391 & 43/PO351
IP: Logged
Message:
can any body have an solution,I have an 98 dakota with a3.9 and I ben having a 351 code ,change ignition coil but dint fixed the problem, I can drive for 50mi with no problem but sometimes just die on me and it take afew times to start need help
|
Jerry F
Dodge Dakota
JOIN HERE
2/26/2013
10:34:34
| 1997 Dakota /PO351
IP: Logged
Message:
same problem as po351 dakota 12/15/11 post stalls all different times. Code P0351 comes up and replaced Ignition coil twice within 8 weeks (long story). Whats next???????? Did you ever get fixed?
|
CompanyMan
Dodge Dakota
JOIN HERE
2/26/2013
17:21:54
| RE: 11/P1391 & 43/PO351
IP: Logged
Message:
Please take to your local Dodge Dealer.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
