| From | Message |
11atokad
Dodge Dakota
JOIN HERE
10/02/2004
16:48:21
|
 Subject: Raising shift points
IP: Logged
Message:
I'm just looking for assurance I'm doing the right thing. I'm looking at the cable behind the throttle and cruise control cables, and it is pulled by the metal piece that the throttle pulls on (don't know the terminology). I removed a white platic bracket with a "T" on it. The inside of the bracket has teeth that slide into teeth on the housing of the cable. Do I just pull the cable as much as I need to and reinsert the bracket? I noticed that the teeth inside the housing only start to move when I pull on the cable a lot. Does it matter if the teeth looked like they moved or should I just pull the cable a tiny bit? What I'm saying is it seems like if I only pull the cable a little bit and put the bracket back on it's not going to make a difference. Tell me if I'm wrong.
|
11atokad
Dodge Dakota
JOIN HERE
10/02/2004
17:29:24
|  RE: Raising shift points
IP: Logged
Message:
p.s. after setting it should the cable be tighter or go back to original resting position?
|
11atokad
Dodge Dakota
JOIN HERE
10/03/2004
19:01:22
| RE: Raising shift points
IP: Logged
Message:
So do I have to pull the cable all the way back enough to move the teeth back a few notches, then put the bracket back on, or do I just pull the cable a few millimeters and put it back on? Because the teeth don't move if I pull the cable a little bit.
|
daffydak
GenIII
10/04/2004
12:05:56
| RE: Raising shift points
IP: Logged
Message:
just be careful! its a pretty sensitive adjustment... I messed with the one on my old dak, and i made it a lil too tight. It would smack the rev limiter on the 1-2 and sometimes the 2-3 shift... talk about embarassing LOL!
check out SpeedTweaks they have a pretty good write-up on the TV cable adjustment.
Hope I helped.
00 CC Sport Plus 4.7L 4X4 Auto, 3:55 LSD
Flowmaster orig. 40 series (2 chamber) muffler, adjusted tps to .76V, ported TB, home brew intake setup w/K&N filter, more mods to come!!!
Dan
MOPAR=More Power!!
|
11atokad
Dodge Dakota
JOIN HERE
10/04/2004
16:57:39
| RE: Raising shift points
IP: Logged
Message:
Thanks, that article was helpful
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
