| From | Message |
tek
Dodge Dakota
JOIN HERE
9/07/2004
12:43:08
|
 Subject: blower motor (AC/heater)
IP: Logged
Message:
Has anyone ever had a problem with their blower motor not working? When I slide the switch over to hi or even low, it doesn't blow at all. I checked the fuse and that's fine. The AC compressor and the buttons for the different air flows all work. I'm just trying to find out if anyone has had any problems with theirs before to see if maybe it's just a simple fix before I go ripping into my truck to get the thing to work.
|
?
Dodge Dakota
JOIN HERE
9/07/2004
15:31:56
|  RE: blower motor (AC/heater)
IP: Logged
Message:
What year truck ??
early 90's have " ballast resistor " on firewall
passenger side , just under hood .
|
tek
Dodge Dakota
JOIN HERE
9/08/2004
10:11:23
| RE: blower motor (AC/heater)
IP: Logged
Message:
it's a 96 3.9L (5-speed) :)
|
daveo.
Dodge Dakota
JOIN HERE
9/08/2004
12:47:32
| RE: blower motor (AC/heater)
IP: Logged
Message:
tek,
My '96 did the same thing. On the firewall(passenger side)there is a rectangular plug that plugs into a plate on the firewall. The conections on mine had gotten lose. Needle nose pliers will tighten up the plug ends.(pull the plug off and look in the plug end)
After tightening, I never had any more problems.
Hope it helps,
daveo.
|
?
Dodge Dakota
JOIN HERE
9/08/2004
12:54:41
| RE: blower motor (AC/heater)
IP: Logged
Message:
May need to replace that " ballast resistor "
Remove the 2 screws and pull it out.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
