| From | Message |
Andrew
Dodge Dakota
JOIN HERE
8/29/2004
11:05:15
|
 Subject: Vinyl Decals
IP: Logged
Message:
I just put a vinyl decal on the front of my dakota on the windshield and am wondering how to get out the little bubbles. Will they just work themselves out or do I need to do something?? If anyone had tips that would be helpful. Thank you Andrew
|
bubbles
Dodge Dakota
JOIN HERE
8/29/2004
21:05:01
| RE: Vinyl Decals
IP: Logged
Message:
You had to have the paint under the decal wet/soapy as you install the decal. Then with a squeege work out the bubbles. I have see guys use a small pin to pop the air bubbles but I dont like the way it looked afterword. If the bubbles are really bad you might have to take them off and do it over.
|
chachimacho
Dodge Dakota
JOIN HERE
8/29/2004
21:56:37
| RE: Vinyl Decals
IP: Logged
Message:
I typically poke a hole, hit it lightly with a propane torch (no sh*t) to shrink the vinyl and thumb it down. If you are lucky, you won't even tell it was there.
|
no bubbles
Dodge Dakota
JOIN HERE
8/29/2004
22:30:25
| RE: Vinyl Decals
IP: Logged
Message:
you can take a credit card or drivers license and hold it at about a 45 degree angle and use the sides to get the bubbles out. doesnt leave holes in the decal and looks really good afterwards.
|
Shortie
Dodge Dakota
JOIN HERE
10/29/2004
04:39:12
| RE: Vinyl Decals
IP: Logged
Message:
Im in the sign business and i use vinyl all the time. just use a hair dryer and try working them out slowly with your finger
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
