From | Message |
Zep Dodge Dakota JOIN HERE
2/29/2004 13:57:10
|
Subject: headlight removal IP: Logged
Message: I'm trying to install some clear corners I got by following the instructions I've found on this site. Only thing is though, the screws between the headlight and corners won't come out past a certain point. Do I need to remove the screws on top of the headlight for the screws on the sides to release all the way. If so is there some trick to removing these because they won't come out at all, the top ones won't even budge. It's like they're frozen in place even after I sprayed them with a little WD40.
|
Phil Dodge Dakota JOIN HERE
2/29/2004 16:46:32
| RE: headlight removal IP: Logged
Message: Based on my '02 all you have to do is remove one Torx 10 screw - it's located on the clear corner assembly right at the base of the turn signal and clear triangle. Once you back that screw out - you can take it all the way out but don't have to - the entire turn signal assembly will slide forward. The headlight unit is fastened with 3 more bolts but do not have to come out to remove / replace the turn signal / clear corners.
|
Zack7687 Dodge Dakota JOIN HERE
2/29/2004 18:27:09
| RE: headlight removal IP: Logged
Message: I did the same on my 99. One screw and its cake from there.
Zack
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|