| From | Message |
dak
Dodge Dakota
JOIN HERE
1/13/2003
18:15:34
|
 Subject: center portion of bench seat
IP: Logged
Message:
i have the seat that is like two buckets and a flip up console/armrest/seat and i was wondering how to get just that center part out. do i have to take my seats out with it first or can i just unbolt the center part alone.
|
DakotaJeff
Dodge Dakota
JOIN HERE
1/13/2003
20:41:29
| RE: center portion of bench seat
IP: Logged
Message:
Hmmm..(same set-up..took them out for racing buckets)....if i remember correctly..you can just unblot the center section...be patient cause there are like pins that hold the two brackets together
Jeff
http://dangerousobsession.tripod.com/jeff.htm
|
IBSRJOE
Dodge Dakota
JOIN HERE
1/14/2003
09:17:55
| RE: center portion of bench seat
IP: Logged
Message:
THE EASIEST WAY IS TO ATLEAST UNBOLT THE SEATS AND THEM YOU CAN FOLD THEN FORWARD. ONCE THIS IS DONE THE CENTER SECTION IS VERY EASY TO REMOVE
|
Greg555
Dodge Dakota
JOIN HERE
1/15/2003
17:18:28
| RE: center portion of bench seat
IP: Logged
Message:
yeah its much easier to just unbolt the seats and tilt them forward. much much much easier that way
Greg
|
jeff
Dodge Dakota
JOIN HERE
2/10/2003
14:49:34
| RE: center portion of bench seat
IP: Logged
Message:
i just done this to mine unbolt the seats and there are bolts underneathe but then there are little bracket i just took a hammer and beat mine off
|
Deep Purple
Gen III
2/11/2003
13:05:33
| RE: center portion of bench seat
IP: Logged
Message:
Mine was riveted together as well as bolted. You can drill the rivets out and separate the console.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
