| From | Message |
conig
Dodge Dakota
JOIN HERE
10/17/2002
18:59:18
|
 Subject: to those with the fabtech. a ?
IP: Logged
Message:
for all of those that have a fabtech, how is the rear end of the truck lifted? Isn't it with an add a leaf? how does an add a leaf work on a truck with the axle over the spring, if my thinking is correct wouldn't this lower the truck?
right now my truck is racked backwards and I would like it level so I only need about an 1 inch of height in the back.
can this be acheived with a set of those helper spring airbags? cause those would be benificail for towing and carrying heavy loads.
|
rivermaniac
Dodge Dakota
JOIN HERE
10/17/2002
19:47:24
| RE: to those with the fabtech. a ?
IP: Logged
Message:
the add a leaf from fabtech lifts the truck 1 1/2 " and on 2wd the leafs are under the axle on 4x4 they are over I beleive , either way It'll raise your truck that much , and will give you better loading capacity and also ride a little stiffer , for my taste It's fine better than stock I tink , but it's not like night and day difference , just a little ........
|
conig
Dodge Dakota
JOIN HERE
10/18/2002
11:25:46
| RE: to those with the fabtech. a ?
IP: Logged
Message:
thanks I should be ordering some from rough contry shortly.
|
conig
Dodge Dakota
JOIN HERE
10/18/2002
11:25:53
| RE: to those with the fabtech. a ?
IP: Logged
Message:
thanks I should be ordering some from rough contry shortly.
|
Chaximus
Dodge Dakota
JOIN HERE
10/18/2002
12:39:19
| RE: to those with the fabtech. a ?
IP: Logged
Message:
I used the fabtech add-a-leaf and it didn't raise it enought to be level with the front so i got some rear 2 inch shackles and they did the job :) more articulation too :)
|
stealwings
Dodge Dakota
JOIN HERE
10/19/2002
19:13:29
| RE: to those with the fabtech. a ?
IP: Logged
Message:
I have the Fab tech 3 inch kit and the back end is level with the front. I don't know about 1 1/2 inch with the add a leaf but on the fab tech kit, but it deffinately gives 3 inches on the 3 inch kit. Greg
98 Dak, 3.9 liter, 3 inch Fabtech, 3 inch Body with 33x12.5 BFG's
|
rivermaniac
Dodge Dakota
JOIN HERE
10/19/2002
21:30:36
| RE: to those with the fabtech. a ?
IP: Logged
Message:
the truck stock sits higher in the back than front , so when you lift your truck 3" in the front you raise the back 1 1/2 " call fabteck and ask how much the add a leafs raise the rear , call 4 wheel parts ............. you'll see
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
