| From | Message |
Greg
Dodge Dakota
10/28/2001
14:45:04
|
 Subject: getting a lift....
IP: Logged
Message:
hey, i have a '97 2wd dakota, how would a 3' lift look on it and what would be the biggest tires i could fit on it? thanx in advance.
Greg
|
Knobbyman
GenIII
10/28/2001
15:29:45
| RE: getting a lift....
IP: Logged
Message:
A 3 foot lift .. HOLY! ;-) I'm gussing you ment 3" anyway on a 97 you should be able to fit 32x11.50x15. If you have 15x7 wheels will work for you.
'01 Graphite QC 4x4
4.7 3.55 LSD
http://www.knobbyman.com
|
CadetDak
Dodge Dakota
10/30/2001
01:44:25
| RE: getting a lift....
IP: Logged
Message:
I used to have a 97 2wd till I got the 01 QC I had a three inch fabtech suspension lift and a three inch body lift, which would clear 33X12.50s and that rubbed a little bit so I'm not so sure that the 32s will fit since you will have 3 less inches of lift then I did.
|
Mike W
Dodge Dakota
10/30/2001
11:29:45
| RE: getting a lift....
IP: Logged
Message:
CadetDak, did you have any problems with steering or alignment problems with your lift? I might get one for my 2001 2wd QC and I want to make sure there are no additional problems.
|
CadetDak
Dodge Dakota
10/30/2001
14:36:28
| RE: getting a lift....
IP: Logged
Message:
no I didn't encounter any steering problems. But lkeep in mind you do have to buy new rims for the lift. The stock rims from what I was told will cause problems due to the beefer ends on the new a-arms that come in the kit. If fact I'm dissapointed that Fabtech doesn't make one for my 4x4 QC I was extremly happy with the fabtech lift. But like I said if you get the body lift as well and decide to mount 33s you'll have to do a little trimming of the fender well, nothing that is seen just trimmed a little on the inside.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
