Dodge Dakota ForumDodge Dakota PhotosDodgeDakota.net Membership
  Forums   Forum Tools
00:22:05 - 12/20/2024

Raised / Lifted Dakotas
FromMessage
JEFF
Dodge Dakota
JOIN HERE


3/02/2004
18:55:36

Subject: Does any one else have this problem
IP: Logged

Message:
I have a gen 3 dakota 4x4 and I run 31 mud terrains. the ? is does any one else have a problem with when they turn the wheels while driving a clunkin sound allmost like if the tires were hiting the front bumper ( i have plenty of clearence) and i am starting to think it might be the cv joints could this be true?



jasonjmw
Dodge Dakota
JOIN HERE
 Email

3/02/2004
20:54:12

RE: Does any one else have this problem
IP: Logged

Message:
I have a '97 4x4 ext. cab 5.2V8 and mine does the same thing but it sounds more like they rub the frame. Let me know how you make out
--Jay



99Dak5.2L4x3
Dodge Dakota
JOIN HERE
 Email

3/03/2004
10:01:54

RE: Does any one else have this problem
IP: Logged

Message:
It's probably your upper ball joints. Me and 10 other million people on this board would agree.

If you are getting that popping clunking noise while turing right or left over speed bumps or small inclines it's because your ball joints have probably worn out. Most people replace them with the moog greasable joints from www.rockauto.com. Do search on this site for ball joints and you'll be better able to pin point your problem but that's my 1st guess.

Bill
Austin, TX



JEFF
Dodge Dakota
JOIN HERE


3/03/2004
17:35:29

RE: Does any one else have this problem
IP: Logged

Message:
Hey thanks for the info. I will hafta check it out. do they make greasable lower ball joints too?



sethco1
Dodge Dakota
JOIN HERE
 Email

3/09/2004
04:59:07

RE: Does any one else have this problem
IP: Logged

Message:
you can also get the moog parts from o'riely, thats where i got mine. make sure they get you the 4x4 and not the 2wd ones(there bad about that even if you tell them). My 97 4x4 5.2L dak was all over the road and had to get a new driver side hub(they dont make bearings there built-in), upper and lower ball joints, and inter and outer tie rods. And lowers i believe have grease certs.



   P 1


Post a reply to this message:

Username Registration: Optional
All visitors are allowed to post messages


Name:
Email:
Notify me when I get a reply to my message:Yes  No

Icons:            

          

Subject:
Message:
 



Home | Forums | Members | Pictures | Contact Us

This site is in no way affiliated with Chrysler or any of its subsidiaries.