| From | Message |
Jake
Dodge Dakota
JOIN HERE
11/26/2003
10:30:15
|
 Subject: 1991 Dodge Dakota
IP: Logged
Message:
I have a 4 inches lift on it I wanna put a solid axle and go about 10 inches is there any kits out there like the toyota ones ?? and what axle are poeple useing ?? Thanks you
|
tj
Dodge Dakota
JOIN HERE
11/26/2003
18:23:51
|  RE: 1991 Dodge Dakota
IP: Logged
Message:
i have a 92 that i put a solid axle on. did my self, wasn't to hard. but to ansrew your question no there is no kit to buy. but i will help if need be, i did all the work myself so unlike others i personal know what goes into doing something like this
|
Jake
Dodge Dakota
JOIN HERE
11/27/2003
14:20:21
| RE: 1991 Dodge Dakota
IP: Logged
Message:
Thanks TJ
any pics and a parts list would help me out alot... I have seen step by step on a toyota and it is just like it .... I don't think it will be that hard ... But like i sad pics and a parts list would be a good start thank you again for your time
|
tj
Dodge Dakota
JOIN HERE
11/27/2003
15:40:43
| RE: 1991 Dodge Dakota
IP: Logged
Message:
sure jake. i don't think i can post pic here but i will send them to you.
parts.
FOR LIFTING FRONT
*front and rear axles from 79 frod bronco f 150
*6" lift front coils "superlift" for the bronco
*dak stock front driveshaft
*all brackets off the ford frame. shocks, coil perch
* 4 degree offset bushings for front
* stock ford radial arms and bracket
LIFTING REAR
* custom rear drive shaft
* new spring peach to weld on the rear axle at the proper with and degree.
* i used 8" lift spring custom made. didn't want blocks.
STEARING
* very simple used factory parts from dodge and ford nothing custom made cheaper and easier to replace.
this should get you started if you want pics let me know give me an email
later
|
Jake
Dodge Dakota
JOIN HERE
11/27/2003
18:10:11
| RE: 1991 Dodge Dakota
IP: Logged
Message:
crazer@pc-intouch.com
Thanks again for the help
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
