| From | Message |
jr
Dodge Dakota
JOIN HERE
11/19/2003
23:09:18
|
 Subject: air box relocation
IP: Logged
Message:
i put a 3" body lift on a 01 dakota 4x4, and can not seem to get the air box in its proper place, the hose is pulling down on the tranny stick, and the last time i went wheeling i soaked my cold air intake, i want to put the box back on
thanks jim
|
billy
Dodge Dakota
JOIN HERE
12/01/2003
13:17:39
| RE: air box relocation
IP: Logged
Message:
if you were deep enough to soak the filter, then you would have just sucked water into the stock air box. I have an 02 model and i believe we have the same airbox setup. there should be a hole in your fender where you have a plastic funnel coming out of your airbox meets to recieve air. turn the funnel up and down and that'll give you a little bit more clearance for deep crossings. As for the body lift affecting your airbox, i don't know. I have a 3 in lift on mine and everything was fine with it until i replaced the intake.
|
Perpetrate
GenIII
12/01/2003
13:29:33
| RE: air box relocation
IP: Logged
Message:
I had to ditch my K&N FIPK because the body lift changed all the angles and nothing fit. I tried to run the filter without the sheild but the fan flung the water right onto the cone filter. Now I have a 14" open element on top of a Power Aide TB Spacer. This way it will take alot of water to soak this filter. I will know if I have a problem after my next Clear Creek trip in Jan 04.
http://www.geocities.com/ridemoreworkless/TrannyCooler.jpg
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
