| From | Message |
Ben
Dodge Dakota
JOIN HERE
3/22/2003
23:06:05
|
 Subject: Axle Flip Kits for 2wd
IP: Logged
Message:
Anyone used this? how would i adjust the front height to level it out afterwards? any Do's Dont's?
Ben
|
Jeff
Dodge Dakota
JOIN HERE
3/23/2003
05:28:00
| RE: Axle Flip Kits for 2wd
IP: Logged
Message:
There is currently no way to lift the front of a 2wd Dakota enough to sit level should you decide to flip the rear springs. The most suspension lift you can get out of a Dakota (without other problems) is around 3" inches. A rear spring over axle flip will in my opinion look terrible with only 3" inches of front lift.
My advice - don't do it.
Jeff @ PLC
|
conig
Dodge Dakota
JOIN HERE
3/24/2003
16:42:48
| RE: Axle Flip Kits for 2wd
IP: Logged
Message:
how much height will the flip give? 3inches? so it would look kinda like the truck does stock or a zr2.
were would I get one if I wanted to try it?
|
ian
Dodge Dakota
JOIN HERE
3/24/2003
18:25:42
| RE: Axle Flip Kits for 2wd
IP: Logged
Message:
an axle flip with give the truck around 5 inches in the rear.
ian
|
eric
Dodge Dakota
JOIN HERE
5/26/2003
01:51:03
| RE: Axle Flip Kits for 2wd
IP: Logged
Message:
i saw that the bajadak had an axle flip conversion and want to try it. i have a 3" fabtech lift and im trying to fab some lower control arms for more lift and travel in the front. i could use any information that you have to offer.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
