| From | Message |
jeremy03cc RT
Dodge Dakota
JOIN HERE
9/15/2003
18:07:10
|
 Subject: IntensePerformance STGIII/chk eng light!
IP: Logged
Message:
i just installed the stage3 intense performance with ceramic canister on my 2003 cc r/t and besides not being able to figure out what in the hell size socket i needed for most of the work(i tried every damn thing)so i had to use a damn crescent wrench for the whole thing( what a pain in the wazooo)after all this i got hooked up and took it for a test drive. low and behold the damn check engine light came on!!! so i went home and reset the pcm after that all was well. just food for thought....
|
Sidewinder
Dodge Dakota
JOIN HERE
9/15/2003
20:26:22
|  RE: IntensePerformance STGIII/chk eng light!
IP: Logged
Message:
8mm wrench or socket will fit the little stuff like hose clamps and such. Seems like everything is either 8 or 10 mm. Speaking of 10 mm, use this wrench to disconnect the pos batt cable. They say it will help computer learn better. Chechk to see if your IAT sensor is installed correctly with no leaks. I installed my stage 3 along with a fastman throttle body 2 weeks ago on my 4.7, no problems yet. I had to extend the Iat wire a few inches. Did you do this and if so are your splices OK.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
