From | Message |
Robbie Dodge Dakota JOIN HERE
1/14/2003 13:44:04
|
Subject: Threw a code... 0300 IP: Logged
Message: Well my M1 Flash was running great yesterday and then this morning while it was warming up, my check engine light came on. I check the code and it said "Multiple cylinders misfiring" ... Will octane booster take care of this? If so, what about using Toluene?
|
R/Truck Dodge Dakota JOIN HERE
1/14/2003 16:17:58
| RE: Threw a code... 0300 IP: Logged
Message: I think you may have a bigger problem then fuel additive can fix. Did you buy chance mess with your sparkplug wires?
|
MikeD *R/T*
1/14/2003 19:07:48
| RE: Threw a code... 0300 IP: Logged
Message: What do you have done to your truck? I have that code thrown but I have a cam so my computer doesn't know what it is so it throws a misfire code.
If you don't have a cam then I dunno what it could be.
You put the M-1 flash on your truck right? Well if your truck is pretty much stock it might be seeing too much spark advance than your truck may know what to do with.
~Mike~
Get In...Sit Down...Shutup...& Hangon
|
rtdkota R/T
1/14/2003 21:27:09
| RE: Threw a code... 0300 IP: Logged
Message: Mine gets a 300 only when I hit the juice with an empty bottle (flood-- fuel only)--- I get a 303 occationally if it's cold-- I run 2 step colder plugs.. It's an ignition thing-- check your wires, plugs, etc.
Sam
RTDKOTA
|
Robbie Dodge Dakota JOIN HERE
1/14/2003 21:50:01
| RE: Threw a code... 0300 IP: Logged
Message: Well I drove it about 10 miles w/ the thrown code from work to band practice. Then after practice I went to go home and it would barely start, then i would have to keep reving it to keep it from dying. Then it just plain wouldnt start. So I pulled the neg battery cable and reset the compter, problem solved. Perfect idle and no knocking. Wierd huh?
R.
'02 5.9 SLT Durango
B&G M1 Flash, M1 w/ xl turtle, 360degrees coldair, 180 thermo, 3923's, magnaflow muffler
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|