| From | Message |
92DAK
Dodge Dakota
JOIN HERE
9/11/2002
21:15:23
|
 Subject: I Searched, but couldn't find an answer
IP: Logged
Message:
I looked on the search for my question, but couldn't find my answer. When installing the M-1 on an EGR equipped truck, do you use a block off plug in the bottom of the plenum...where a turtle would sit. This is the hole that is directly below the throttle body. I'm sure someone has answered this a thousand times before, but I couldn't find it.
|
Dakaty
GenIII
9/11/2002
21:37:17
|  RE: I Searched, but couldn't find an answer
IP: Logged
Message:
My install instructions said to block the hole on non EGR models and to leave it open on EGR models.
It makes since because the hole allows a direct connection between the EGR (which mounts at the rear of the manifold) and the inside of the intake.
|
DaveR
GenII
9/11/2002
23:14:12
| RE: I Searched, but couldn't find an answer
IP: Logged
Message:
You got it. Leave the hole below the TB open and plug that hole that is on the EGR runner.
|
greendak98
Dodge Dakota
JOIN HERE
9/18/2002
23:40:07
| RE: I Searched, but couldn't find an answer
IP: Logged
Message:
hey isnt that a song?
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
