| From | Message |
E
Unregistered
4/07/2001
20:41:40
|
 Subject: MSD Digital 6 Help
IP: Logged
Message:
Question for anyone with MDS digital 6 hooked up.
Where did you connect the red and white wires coming from the MSD box? The diagram shows the red should connect to a green/orange wire coming from the ignition key, and the white should connect to a Black/Grey wire coming from the points, but I havent been able to find them.
Thanks
|
Wayne
GenIII
 
4/07/2001
21:40:04
| RE: MSD Digital 6 Help
IP: Logged
Message:
Mine were inside a wire loom to the coil. On a '99 Dakota that is on the passenger side,front corner of the valve cover.
Wayne Van Metre
'99 CC SLT 5.2/auto/3.90 anti spin
|
Bernd
GenIII
4/08/2001
00:15:57
| RE: MSD Digital 6 Help
IP: Logged
Message:
You splice it into the wires going to the coil. Basically cut the wire from the coil connector (about 3-4" of leadway) and splice them in.
Red/White go to the harness and the orange/black go to the connector.
The instructions (page 20 I believe) show the late model Dodge connections. Ignore the ignition key (note the coil+ wire).
Bernd D. Ratsch
1997 Dodge Dakota SLT
Supercharged w/Nitrous
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
