Forums
Forum Tools
|
 |
08:39:02 - 11/17/2024
Dakota Performance
| From | Message |
Todd Bouton
Dodge Dakota
JOIN HERE
5/03/2002
14:56:53
|
 Subject: Hey CW, those HO cams....
IP: Logged
Message:
Curtis,
Todd Bouton here.
If memory serves me right. The only differences you found thus far was increased lift slightly on the exhaust side?
Theres' a set here in my area for $155. I have a 5spd, LSD, 01 4.7,QC, don't race it, but like to toy with power. I've ported the TB, Home brew intake, Iat adjuster. Would I see gains enough to be worth it?, runs pretty good now.
Thanks,
Todd
|
Dr0p0ff
GenIII
5/03/2002
16:22:23
| RE: Hey CW, those HO cams....
IP: Logged
Message:
Todd have u looked at the dyno #'s for those cams? not too too shabby. 20+ ft-lbs the WHOLE torque curve, and no less than 5hp gains throughout the power curve. the torque is worth it me thinks.
Keep On Truckin!
Sgt G
|
CW
GenIII
5/03/2002
19:40:14
|  RE: Hey CW, those HO cams....
IP: Logged
Message:
According to the specs in the book the only change is on the intake side going from .440" to .472", if memory servs correct. No change on the exhaust. It is a highly recomended mod for vehicles that are a little over weight. I think KRC said 13hp and 26ft/lbs. It is on V-8 board. I love the added torque so much that I ordered a HO intake manifold as well.:) I will see if that is a good thing not.
2001 4.7 RC 5sp 3.92 LSD
Click on thumbnail for mods.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
