| From | Message |
Mopar318
GenII
11/01/2006
00:00:02
|
 Subject: Making my own meth/water injection
IP: Logged
Message:
Lets get rid of google ads
I did some research and I drew up my design and bought the parts I needed. Tonight I ordered the following.
NOS brand Fan spray Nozzle
NOS brand .030" Jet
3 A/N-NPT connector
1/4" high pressure gas/methol fuel line (hopefully this wont corrode)
Shurflo 150psi pump. (seals designed for meth/alco use)
1-25 psi Boost swith
22psi actuated check valve.
In dash warning light (So I know when its activated)
Im still going to need a few fitting, some wire, and a couple relays but i can get them all locally. It wont be 2 months till I can see my truck again anyways.
I have less than $200 in parts and I should be able to build a nice system.
Old setup: 1/4 mile on old setup: 13.965 @ 100.10 MPH, Crappy 2.236 60' on street tires
Mods: Paxton NOVI 2000 supercharger @ 10 #'s, M1 4Bbl, F&B 58mm TB, Gibson headers, JBA Y-pipe, and a Locker
|
Kevin
Dodge Dakota
JOIN HERE
11/01/2006
00:19:51
| RE: Making my own meth/water injection
IP: Logged
Message:
We don't see the google ads anymore. Read this thread and you won't have to, either.
http://www.dodgedakota.net/boards/per/13227.html
|
TexasTodd
Dodge Dakota
JOIN HERE
11/02/2006
10:02:19
|  RE: Making my own meth/water injection
IP: Logged
Message:
Mopar 318, (I forget your first name, Mark?),
Will this system do much, for my normally aspirated 4.7? Or is this just more mods for your S/C?
For that price, I'd build one too, if it where to give me any gains. Assuming this is also an on demand system like NOS, not full time like the S/C.
|
Mopar318
GenII
11/02/2006
11:58:45
| RE: Making my own meth/water injection
IP: Logged
Message:
Yeah this is mostly for forced induction. It may help a small bit on a N/A engine but not enough to justify the cost. I am not intercooled so this is one way of doing it. People have seen 100+ Hp gain with the meth injection system alone. I have it hooked up to a pressure switch that will only turn on the pump when its in boost.
For you nitrous oxide would be better, You could probally run a 75 shot on the 4.7 without blowing something up like the plastic intake!
Old setup: 1/4 mile on old setup: 13.965 @ 100.10 MPH, Crappy 2.236 60' on street tires
Mods: Paxton NOVI 2000 supercharger @ 10 #'s, M1 4Bbl, F&B 58mm TB, Gibson headers, JBA Y-pipe, and a Locker
|
RaZoR1
Dodge Dakota
JOIN HERE
11/03/2006
18:19:59
| RE: Making my own meth/water injection
IP: Logged
Message:
Where are you going to spray??? I have the kenne bell and have no way to spray after the air is compressed. I would have to do it just after the throttle body i assume???
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
