From | Message |
bigdave Dodge Dakota JOIN HERE ![Email](http://www.dodgedakota.net/amb/icons/email.gif)
6/11/2005 21:52:24
|
Subject: RR's and stock pushrods?? IP: Logged
Message: Hi, I am putting a cam, Comp Cam RRs and various other performance parts on my 3.9 right now. Problem is I just realized I didnt receive my Hi-performance pushrods from KRC, they are backordered. I have new stock pushrods, will they work or will I destroy them?
Thanks
Dave
|
gen1dak Dodge Dakota JOIN HERE
6/11/2005 22:39:43
| RE: RR's and stock pushrods?? IP: Logged
Message: The problem with the stockers is they are thin-walled and at higher lifts, and higher engine speeds, they will tend to bow a lot, and all this generates valvetrain noise and harmonics that will damage the engine over time. Also, when the rods bow, they cut into the net lift on the cam, so you lose some of the performance you just added. Get the better pushrods.
|
bigdave Dodge Dakota JOIN HERE ![Email](http://www.dodgedakota.net/amb/icons/email.gif)
6/11/2005 22:45:44
| RE: RR's and stock pushrods?? IP: Logged
Message: Thank you, Gen1dak
|
N56629 Dodge Dakota JOIN HERE
6/11/2005 23:39:20
| RE: RR's and stock pushrods?? IP: Logged
Message: Some manufacturers claim that you don't need different rods unless you are cranking more than 5500 rpm. However, good rods are cheap insurance.
|
| P 1 |
|
Post a reply to this message:
Username Registration: Optional All visitors are allowed to post messages
|