| From | Message |
Joe E.
Dodge Dakota
JOIN HERE
3/25/2002
23:02:08
|
 Subject: **GenI Spindles** read!
IP: Logged
Message:
HI all 2wd GenI Daks out there,
On another post concerning lift spindles, I asked about someone making lift spindles for 1987-1990(1991?) 2wd Dakotas. A guy named Richard said he would be willing to design and manufacture them IF he could get enough inrtest in the product. So what I am asking you is if your intrested in these spindles, or every think you will be, please send an email to richardmomeni@hotmail.com
and request he look into making this happen. PLease help me out here. My 1990 2wd Dak has 5inches of lift and I can only run 31x10.50s With spindles, I am hoping to run 33x12.50s. Thanks for your time. Have a good one!
Joe E.
|
Mike S
Dodge Dakota
JOIN HERE
3/25/2002
23:13:32
| RE: **GenI Spindles** read!
IP: Logged
Message:
Wouldnt Gen I spindles also work on Gen II's? I thought the only difference on the front suspensions was 5 lug rotors?...
How much are we talking here?
An how did you get 5" lift outof your 2wd?
Thanks,
Mike
93 V6 5speed
|
Joe E.
Dodge Dakota
JOIN HERE
3/25/2002
23:37:04
| RE: **GenI Spindles** read!
IP: Logged
Message:
Mike,
I am not sure about the spec.s on Gen I and II spindles. Richard has said they are likely similar but he will also probably have to check on it in depth.
On my truck, I have a 2in suspension lift and a 3in body lift. I also have 2in shackels on the rear to give me a little boost. This gives me 5in. of lift. The 2in susp. was factory made. The 3in body was a trailmaster 4x4 lift customized to run on my 2wd. Thanks for your intrest in these spindles. I hope to see you write richard on this. Thanks.
Joe E.
|
Joe E.
Dodge Dakota
JOIN HERE
3/28/2002
14:35:33
| RE: **GenI Spindles** read!
IP: Logged
Message:
taken it to the top.
Joe E.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
