| From | Message |
Chad
Dodge Dakota
JOIN HERE
4/11/2009
23:27:47
|
 Subject: No high range
IP: Logged
Message:
I am new to Dakota's and have a bit of a problem. I just picked up a 93' ext cab v8 dakota and for some reason I don't have high range but I do have low. I have been wheeling it pretty heavy for about six months now and am getting tired of only having low. Do these have a vacuum switch that controls high range or is something shot. If it is a t-case problem do these Np231's have the same bolt pattern as a Jeep np231 I have a couple jeep ones laying around and have considered swapping one of them in.
|
Les
Dodge Dakota
JOIN HERE
4/13/2009
19:35:55
| RE: No high range
IP: Logged
Message:
Same. Swap 'em.
|
Walt
Dodge Dakota
JOIN HERE
4/13/2009
21:27:45
|  RE: No high range
IP: Logged
Message:
No vacuum CAD on a 93 Dakota. Your problem is either a linkage adjustment issue or an internal problem.
There are multiple variations of the NP231. Your Dodge has a NP231D, the Jeep is a NP231J and some GM's used the NP231C. There are differences in shaft sizes and they are not interchangeable without modification.
|
super bee
GenI
4/13/2009
22:34:07
| RE: No high range
IP: Logged
Message:
i found out a 1995 v8 NP231 is different than a 1990 v6 NP231
shaft sizes were different and the output spline was different
1990 sport RC SB, 1995 318drivetrain, 3.92 gears (came with truck) Powertrax "traction system", 95 dash/steering wheel, hearthrob exhaust, headers, cutout after y-pipe, necessary electric fan add-a-leafs, 30x9.5 mud tires, cranked T-bars, AR 39 15x8 rims, grill guard, roll bars
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
