| From | Message |
someoneelse
Dodge Dakota
JOIN HERE
6/04/2002
22:32:20
|
 Subject: Question for Kota on 20's
IP: Logged
Message:
Since you seem to have alot of experience with dropping these trucks...
I have a DJM 3/5 on my reg cab with the 318. I want to tuck 17's and i dont want to use blocks. Can i just add Belltech 2" leafs onto the shackle/hangers in the rear with a notch and up front use the 2" lower drop arms w/ the 3" lowering springs (make it 5/7) Is this recommended and will it work/tuck? I wanna see if i can work with what i have, with out spending alot of money bagging, etc. thanks for your time.
|
Kota on 20
Dodge Dakota
JOIN HERE
6/06/2002
19:21:00
|  RE: Question for Kota on 20's
IP: Logged
Message:
YO! Take a torch to the frame and C-notch that bad boy, then weld on some steel plates, drink a cold Corona, and add the drop blocks, and just heat the front coils with a torch, while drinking another Corona, and watch the front sag,then drop till where you want it, This is how I did my truck. It Mohot Cool ride.
|
D
Dodge Dakota
JOIN HERE
6/06/2002
21:01:16
|  RE: Question for Kota on 20's
IP: Logged
Message:
damn, someone is impersonating
again....(not really Kota)
|
someoneelse
Dodge Dakota
JOIN HERE
6/07/2002
03:58:32
|  RE: Question for Kota on 20's
IP: Logged
Message:
Yeah, what he doesnt know is that if the real kota on 20's wanted to complain to the webmaster and the webmaster got enuf complaints about this guy impersonating registered users, the webmaster could really easily find his IP address and have somebody take care of him, he he he, webmasters are called webmasters for a reason and they watch out for their registered users.
So, D i've seen you here a lot, what would you recommend?
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
