| From | Message |
conig
Dodge Dakota
JOIN HERE
5/28/2002
15:40:39
|
 Subject: u bolts for rear axle. help.
IP: Logged
Message:
I tried again to lower the rear of my dak 2 inches and was yet again unsuccessfel. my question for ya'll that use blocks and ubolts is do you use the ubolts that are kinda squared at the end or the rounded ones? I have the rounded ones and they will not stretch over the axle.
really want to level my dak, I have tried 3 times and can't get it to work with the u-bolts in my kit(rounded ones) are the square ones as strong because they should fit.
|
FastD
Dodge Dakota
JOIN HERE
5/28/2002
16:36:04
| RE: u bolts for rear axle. help.
IP: Logged
Message:
I have a 2000 Durango I lowered and the ubolts didn't fit on mine either, so I went to NAPA auto parts and bought some "bigger" bolts. take the ones in the kit with u and tell the guy that it needs to be a tad wider to go over the axle. Hope this helps!
|
1Flamed92Dak
Gen I
5/28/2002
23:24:51
| RE: u bolts for rear axle. help.
IP: Logged
Message:
I got mine from a local race shop. You may wanna look there if you have one in your town.
|
Rob
GenIII
5/29/2002
17:44:13
| RE: u bolts for rear axle. help.
IP: Logged
Message:
Daks have two diffrent rear ends. when I ordered my drop I did the a arms in the fron then when I got to the back the u bolts were to small.I had to get ubolts for an r/t because I have the same 3 5/8 housing. Probably what you got
 180 thermostat,Z-Tube,Magnaflow exhaust,jet mod,,Auto lite 3923's,SS bumper cover,Stull full billet grill and shell,SS rollpan,Apc clear corners&euro tails,DJM 2inch control arms & 3 inch block
|
conig
Dodge Dakota
JOIN HERE
5/29/2002
19:06:43
| RE: u bolts for rear axle. help.
IP: Logged
Message:
I do have the 3 5/8 rear end. the square ones look like they will fit. I'll try napa an see if they have a large enough kit.
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
