Forums
Forum Tools
|
 |
00:34:28 - 12/20/2024
Lowered / Slammed Dakotas
| From | Message |
jopi
GenI
 
1/30/2006
05:16:21
|
 Subject: geometry
IP: Logged
Message:
Message:
Hello,
I must remake the géometry my Dakota (I lowered it approx. 3'' - 3,5 ''.
Somebody have the dimensions of the original adjustments suspension geometry: caster, camber, toe-in, etc... in degree or minute.
Thank you very much
jopi
Go Fast...or Go Home!
|
hipburwig
Dodge Dakota
JOIN HERE
2/26/2006
21:06:47
|  RE: geometry
IP: Logged
Message:
r u talking about alignment specs? u will never achieve original spec with a 3" drop. about the only way u can is if u gring out the slots a little. it will be close. I have 3" drop springs on mine w/ a v8. i have my specs some where, about the only thing u can do is pull the arms all the way out (most poss cam) tighten them down, run your caster sweep and go from there. a little neg cam is ok any how, but the bump steer sucks. with the 3" drop the angle of the outer tie rods relative to the spindle is too drastic. i have gone through 1 rack already
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
|
