| From | Message |
justin
Dodge Dakota
JOIN HERE
4/07/2002
21:13:07
|
 Subject: help with my drop again
IP: Logged
Message:
alright i jacked the truck up and took a look, the control arms look too easy to install ($250 a side!!! i should beat that guy for tryin to pull that crap) but my question is am i going to need the shims or wedge plates for the rear? i looked at the blocks (sumitt 3in blocks) and they already look like they are angled and much as the 2deg. wedge plates. so do i need them? and if i do i have no idea how to put them on. do they slant down towards the front or the rear? thanks for the help
|
kota on 20s
GenIII
 
4/08/2002
13:01:35
| RE: help with my drop again
IP: Logged
Message:
you dont need the shims if you have angled blocks. the angle points toward the front
Eric, 98 5.2 5speed, K&N gen II, 50mm TB, 2bbl M-1, 1.7RR's, JBA ciramic headers, carsound cat, dumped gibson, and a lot more
|
justin
Dodge Dakota
JOIN HERE
4/08/2002
20:34:31
| RE: help with my drop again
IP: Logged
Message:
so the higher part in the back?
|
kota on 20s
GenIII
4/08/2002
20:54:42
| RE: help with my drop again
IP: Logged
Message:
yup
Eric, 98 5.2 5speed, K&N gen II, 50mm TB, 2bbl M-1, 1.7RR's, JBA ciramic headers, carsound cat, dumped gibson, and a lot more
|
justin
Dodge Dakota
JOIN HERE
4/08/2002
22:29:34
| RE: help with my drop again
IP: Logged
Message:
thanks kota
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
