| From | Message |
Andy
Dodge Dakota
JOIN HERE
8/12/2004
21:38:36
|
 Subject: gen1 droping the front
IP: Logged
Message:
Ok i have a gen dak a 1990 3.9 to be exact anyway i put 3 inch lowering blocks in the rear and i dont like how its sits low in the back which i knew it was going to do.Anyway I work for menikey and im a mechinc whateverim not good at spelling but im good at working on anytihng so i was tired of looking at the back being down so i pulled out the gas tourch and had a my buddy joey sit on the fender and heated the springs till they lowered and measured them to make sure they were the same and it look even but it drives very funny it wobbles and i dont like it so, is there anytihng i can buy to do it the right way anything please someone reply asap!
|
DakYoda
Dodge Dakota
JOIN HERE
8/14/2004
00:24:14
| RE: gen1 droping the front
IP: Logged
Message:
get front drop springs and spindles from:
http://www.belltechcorp.com/
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
