| From | Message |
ch4ngv
Dodge Dakota
JOIN HERE
4/16/2004
21:56:01
|
 Subject: Belltech Angled 2" lowering blocks
IP: Logged
Message:
I just picked these up and the instructions don't say which way the taper is supposed to face. Is it meant to tip the diff input up or down?
Thanks
|
down
Dodge Dakota
JOIN HERE
4/17/2004
16:02:18
|  RE: Belltech Angled 2
IP: Logged
Message:
If you move the axle up you tilt it down. If you move the axle down (lift the truck), you tilt it up.
|
kotart13
Dodge Dakota
JOIN HERE
4/18/2004
16:56:07
| RE: Belltech Angled 2
IP: Logged
Message:
i just got through helping my friend install his angled blocks. he thought that he wanted his diff. pointing more downwards, but this caused major vibration problems. titlting the axel down (tall end of the block to the rear) fixed his problem. my susggestion is to install the block, then just look at the u-joint to make sure its not at too much of an angle.
|
UFDakota
Dodge Dakota
JOIN HERE
4/20/2004
19:26:03
| RE: Belltech Angled 2
IP: Logged
Message:
yes, like they said, tall part toward the back, shorter in front...peace
-Dan-
|
ch4ngv
Dodge Dakota
JOIN HERE
4/21/2004
17:57:15
|  RE: Belltech Angled 2
IP: Logged
Message:
Thanks guys you've answered my question.
|
rt13
Dodge Dakota
JOIN HERE
4/22/2004
17:32:53
| RE: Belltech Angled 2
IP: Logged
Message:
woot you see that, someones questions got answeref for once, this thread should go down in history! lol
|
| | P 1 |
|
Post a reply to this message:
Username Registration: Optional
All visitors are allowed to post messages
|
